Keyence DL-CL1 Manual do Utilizador descarregar pdf (Página 61)

3-4 Command Parameter List

3-33

Communicating with the SK-1000 Series

- CC-Link Compatible Network Unit DL-CL1 User’s Manual (SK-1000) -

*3 Use this parameter in combination with the judgment value property or with the

judgment value "invalid," "over," or "under."

If the judgment value is correct, the parameter range is from - 99.997 to 99.998

・ from - 99.999 to 99.999 (SK-050).

• When the current value is over range, "99.999" is stored.

When the current value is under range, "- 99.999" is stored.

When the current value is invalid, "- 99.998" is stored.

When an error occurs, "100.000" is stored.

*4 • When in sample hold:

Value "-99.998" is output.

• When not in sample hold:

The peak value encountered during the sampling period is output

*5 • When in sample hold:

Value "-99.998" is output.

• Wh

en not in sample hold:

The bottom value e

ncountered during the sampling period is output

*6 This is -999.8 when the temperature is not acquired correctly.

*7 This is 999.8 when the humidity is not acquired correctly.

*8 If a prohibited combination of functions is written, it results in "abnormal setting

(1)" For details of each function, refer to the SK-1000 Series Instruction Manual.

*9 The result of the "initial reset request" motion command is included in this item.

Regarding Data No. nn35 (EEPROM writing result), a "0: writing in progress"

status is maintained for 2 seconds after completion of the final write command

transmission to the nonvolatile memory (EEPROM). Writing begins 2 seconds

later, and if completed normally, the result is "1: successfully completed".

[Example] After every-second write command transmissions, a "0: writing in

progress" status is estab lished for 2 seconds. A "0: writing in prog-

ress" status is maintained for 2 seconds after completion of the final

write command transmission, and writ

ing then begins 2 seconds

ter, with a result of "1: successfully completed".

However, writing begins immediately following a initial reset executed in

response to a Data No. nn05 "initial reset request". A "1: successfully com-

pleted" result then occurs if all parameters have been saved to the nonvolatile

memory (EEPROM) approximately 3 seconds later.

- When "zero shift status save" is ON, writing begins immediately for Data No.

nn01 "zero shift execution request" and Data No. nn02 "zero shift reset execu-

tion request".

*10 The command reads the execution result of the "zero shift execution request" or

"zero shift reset execution request" whichever was last issued.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 77 78

Comentários a estes Manuais

Sem comentários

Keyence DL-CL1 Manual do Utilizador Página 61

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Keyence DL-CL1