Keyence BL-700 Series Manual do Utilizador descarregar pdf

CAUTIONS for correct use

Laser Bar Code Reader

BL-700 series

Instruction Manual

Thoroughly read this instruction manual before

beginning operation of the exclusive unit for laser

bar code reader.

Keep the instruction manual in case reference is

needed.

• Be sure to use the 5VDC power supply. If a

power supply exceeding 5VDC is used, the unit

may be damaged.

When the exclusive power supply BL-U1, BL-

U2, N-42 or N-48 is used, use a power supply

having the range suitable for these units.

Otherwise, the exclusive unit may be damaged.

• Avoid applying shocks or dropping the unit as it

is a precision electrical unit. Otherwise it may

be damaged, Pay special attention during you

are moving or

installing the

unit.

• Never carry the units by

holding the cables. Other-

wise units hit each other,

resulting in malfunctions.

CAUTION

Safety information for BL-700 series

 Safety precautions on laser product

The visible semiconductor laser used as the light source.

Use of controls or adjustment or performance of

procedures other than those specified herein may

result in hazardous radiation exposure.

Model BL-700/701/740/741/780/781

Wavelength 655nm

Output 100

Pulse duration

99.5

Ps (IEC60825-1),

Ps (FDA (CDRH) Part 1040.10)

Laser Class

Class 2 Laser Product (IEC60825-1),

Class Laser Product (FDA (CDRH) Part 1040.10)

WARNING

Follow the instructions mentioned in this manual.

Otherwise, injury to the human body (eyes and

skin) may result.

Precautions on class /2 laser products

• Do not stare into the beam.

• Do not direct the beam at people or into

areas where people might be present.

• Be careful of the path of the laser beam.

If there is a possibility that the operator may

be exposed to the specular or diffuse reflec-

tions, block the beam by installing a protec-

tive enclosure.

• Install the products so that the path of the

laser beam is not as the same height as that

of human eye.

• Do not disassemble this product.

Laser emission from this product is not auto-

matically stopped when it is disassembled.

WARNING

96M11736

1 2 3 4 5 6

Resumo do Conteúdo

Página 1 - BL-700 series

1CAUTIONS for correct useLaser Bar Code ReaderBL-700 seriesInstruction ManualThoroughly read this instruction manual before beginning operation of the

Página 2 - System Configuration

2The following FDA(CDRH) label is affixed to the product.When using this product in the countries and/or regions other than U.S.,use the IEC warning/e

Página 3 -  Operating Environment

3Connections* When the exclusive power supply is used, refer to the user’s manual. Connector Pin AssignmentThe pin assignment of the BL-700 connector

Página 4 -  Installation Procedure

4 Installation ProcedureUse the mounting holes in the side panel of the BL-700.z When bracket is not used* Prepare M3 nuts and screws according to th

Página 5 -  BL-700 Series

5Dimensions BL-700 Series(Unit : mm) BL-700 Series (with bracket)5328.526.53.25 46.551.53.259.95836(A)(*)10°φ5.8 2 - φ3.5 (Mounting hole)Laser beamL

Página 6 - E 1110-2

611736E 1071-1 96M11736 2011*3 As for CODE128 using CODE-C as the start and stop charac-ters, the maximum number of digits is 64.* Internal settin