Keyence CV-X Series Manual do Utilizador descarregar pdf (Página 12)

‐ 12 ‐ www.keyence.com

KEYENCE CORPORATION. Vision System Division

✎ Command Execution Procedure Example Save Settings (SS Command)

Check the SS (Save Settings) command operation.

1. Enter "12", the SS command No., in the data memory

corresponding to the PLC Command Address (D100 in this

example).

* The address to use is 1 word.

2. Enter 1 in the data memory corresponding to the PLC

Command Execution Address (bit) (D002 in this

example).

* The address to use is 1 word.

3. The command is executed.

4. Check if the values of the data memory corresponding

to the PLC Command Complete Address (bit) and

Command Result Address (D003 and D200 respectively

in this example) have changed.

When the command is successful: CV‐X writes "1" into Command

Complete Address (bit), and "0" into Command Result Address.

When the command fails: CV‐X writes "1" into Command Complete

Address (bit), and an error code into Command Result Address.

Here is an example of a representative command execution procedure. This section explains an example of executing the SS

(Save Settings) command, which does not use a command parameter, with Command Execute Event set to "Polling". The

screens with blue frames show when the "Registration monitor" function of GX Developer is used for confirmation.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sem comentários

Keyence CV-X Series Manual do Utilizador Página 12