Keyence CV-X Series Manual do Utilizador descarregar pdf (Página 15)

www.keyence.com

KEYENCE CORPORATION. Vision System Division

‐ 15 ‐

✎ Command Processing Flow

To control the controller via PLC‐Link, use the number‐specified commands.

Here is an example of using the PW command (command No. 24) that switches the program settings.

Refer to "Control/Data Output via Commands" in the user's manual to check the commands to use and the

formats of the number-specified commands.

The following must be specified to execute the PW

command:

Command No. (24)

SD card No. (d) of the switch target program settings

Setting No. (nnn)

Specify 2‐word integer values from the data memory

specified as the "Command Address" in order.

The command processing result is stored to the

address specified as the "Command Result Address".

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Sem comentários

Keyence CV-X Series Manual do Utilizador Página 15