Keyence CV-X Series Manual do Utilizador descarregar pdf (Página 3)

365GB

KEYENCE CORPORATION. Vision System Division

‐ 3 ‐ www.keyence.com

1. Before Connecting EtherNet/IP (EtherNet/IP) [Keyence KV Series]

Change the Ethernet settings and then left-click

"OK".

From "Global", select "Communications & I/O" -

"Network".

From "Global", select "Communications & I/O" -

"EtherNet/IP".

Change the EtherNet/IP settings and then left-click

"OK".

1. Checking the Global Settings of the CV-X100 Series

In this section, the set values below will be configured

as an example (change the settings according to the

target device).

•IP Address: 192.168.0.10

•Subnet Mask: 255.255.255.0

In this section, the set values below will be

configured as an example (change the settings

according to the target device).

•Enable EtherNet/IP: Check this box.

•Data Size: 496 bytes

•Data Configurations: Set the desired data

allocations and allocation offset for the bit

address and byte address.

•Decimal Point: Fixed‐point

•Process Priority: Image First

Restart the controller.

This section describes how to establish EtherNet/IP.

[Important]

If it fails, establish a one-to-one connection between the

PLC and CV-X, and follow this manual to configure the

settings and check the operations.

Confirm that it operates properly, and change settings if

necessary.

1 2 3 4 5 6 7 8 ... 19 20

Sem comentários

Keyence CV-X Series Manual do Utilizador Página 3