Keyence LS-5000 Manual do Utilizador descarregar pdf (Página 103)

Chapter 8 RS-232C I/O

8.3 Command List

This section lists all commands and describes each code.

1. Upper line: Character code, Lower line: ASCII code

Note: When the LS-5000 series receives a command other than those listed

above, it sends back the “ERRORCR” message ([E][R][R][O][R][CR]).

Function Command received

Description

[M][#][CR] (#:0 to 4) Send a measured value once.

4DH#0DH

[N][#][CR] (#:0 to 4) Send a measured value continuously.

4EH#0DH

[O][CR] Stop continuous transmission of

4FH 0DH meas ured value.

[T][#][CR] (#:0 to 4) Turns ON the synchronous input.

54H#0DH

[U][#][CR] (#:0 to 4) Turns OFF the synchronous input.

55H#0DH

[Q][#][CR] (#:0 to 4) Reset input.

51H#0DH

[V][#][CR] (#:0 to 4) Auto-zero input.

56H#0DH

[W][#][CR] (#:0 to 4) Resets the auto-zero input.

57H#0DH

[P][#][#][CR] (##:01 to 16) Program number is changed.

50H##0DH

[S][R][CR] Read preset data.

53H 52H 0DH

[S][W] ... [CR] Write preset data.

53H 57H ...0DH

Output of

measured value

Timing

Reset

Auto-zero

Program No.

Selection

Reading preset

data

Writing preset data

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 131 132

Sem comentários

Keyence LS-5000 Manual do Utilizador Página 103