Keyence KV Series Manual do Utilizador descarregar pdf (Página 19)

INSTALLATION PROCEDURE

This section describes how to attach a connected unit directly to a panel, to

a DIN rail, or to a DIN rail with an expansion unit spacer.

■ Attaching a unit directly to a panel

Attach a metal fixture for screw tightening to a KV Series basic unit with set

screws. Then, attach the basic unit with a metal fixture directly to the panel.

■ Attaching a unit to a DIN rail

Hang an upper claw of a KV Series basic unit to the upper side of the DIN

rail, and press the basic unit onto the DIN rain until you hear a click.

■ Removing a unit from a DIN rail

Pull a lower claw of a KV Series basic unit downward from the front direction

using a screwdriver, and then remove the basic unit from the DIN rail.

Attaching an expansion unit spacer

When an expansion unit spacer is attached to a KV Series expansion unit, its

height becomes flush with an AC power type KV Series basic unit.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Sem comentários

Keyence KV Series Manual do Utilizador Página 19