Keyence DL-DN1 Manual do Utilizador descarregar pdf (Página 25)

2-3 Configuring the Data Link

2-9

Connection and Configuration

- DeviceNet Compatible Network Unit DL-DN1 User’s Manual (SK-1000) -

Use the following procedures to configure the data link of the DL-DN1.

Setting the node address

Using the address setting switch, set the DeviceNet node address to be assigned to

the DL-DN1.

• Default value: 63

• Setting range: 00 to 63

When setting the node address of the DL-DN1 from the DeviceNet master unit, set it

in the range of 64 to 99. The DL-DN1 enters PGM mode.

When the DL-DN1 is set in the PGM mode and the power is turned on,

the address of the DL-DN1 is the same as used when the DL-DN1was

started previously.

When the DL-DN1, in the factory default setting, is set to PGM mode,

the node address of the DL-DN1 is 63. Do not start multiple DL-DN1

units in factory default setting in the PGM mode, as that will result in a

network error because of the duplicate node addresses.

Selecting an operating mode

Select the desired operating mode of the DL-DN1 using the operating mode setting

switch.

The data that can be handled in I/O communication varies with each operating mode.

Configuring the DL-DN1

Operating mode setting switch

ddress setting switch

Point

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Sem comentários

Keyence DL-DN1 Manual do Utilizador Página 25