Keyence DL-DN1 Manual do Utilizador descarregar pdf (Página 23)

2-7

Connection and Configuration

- DeviceNet Compatible Network Unit DL-DN1 User's Manual -

2-2

Wiring

This section describes how to wire the DL-DN1.

Refer also to the DeviceNet Installation Manual published by ODVA.

Turn off the power before wiring.

Use the following procedure to connect the DL-DN1 to the DeviceNet.



Recommended cables

For connection between the DL-DN1 and the DeviceNet, use a dedicated DeviceNet

cable conforming to the DeviceNet specifications or a dedicated flat cable.

Do not use non-dedicated cables, as this may inhibit proper commu-

nication.



Trimming the cable

Strip the cable sheath.

Strip approximately 70 mm of cable sheath.

Make sure that the bare part of the shield braid is 6 mm or shorter.

Point

Connecting to the DeviceNet

Point

6 mm or shorter

Approx. 70 mm

Shield braid

Sheath

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 83 84

Sem comentários

Keyence DL-DN1 Manual do Utilizador Página 23