Keyence EX-V Series Manual do Utilizador descarregar pdf (Página 26)

Chapter 2 Quick Guide to Basic Mode Operation

7. Set the upper value for the tolerance limit.

For a press, set the threshold value to the amount of the rise of the bottom dead

center due to swarf.

1) Press the

key.

• The sensor enters the tolerance limit setting mode.

• The setting number is displayed.

Note: Press the key for a short time. When the key is pressed for 2 seconds or

longer, the sensor enters the function setting mode and displays “Ab[d”. If you

accidentally put the sensor into the function setting mode, press the key again

to return to the measurement state.

2) Press the

key to display the desired setting number.

• Pressing the

key changes the setting number sequentially.

•“x” indicates the hysteresis setting. (➮

Refer to page 85.

)

Reference: Four kinds of tolerance limit values (“0” to “3”) can be saved in the

memory. The registered setting numbers can be switched using external signals.

(➮

Refer to page 4.

)

3) Press the

key.

• The sensor automatically enters the HIGH limit value setting mode.

• The setting value is displayed in red and the HIGH indicator illuminates.

SET

CALL

HIGH TIM

LOW

FUNC

UTILITY

MODE

CALIB

Mode No

key

HIGH TIM

LOW

Stripper or upper die

Die set

Lower die

Upper limit value

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 119 120

Comentários a estes Manuais

Lao 20 Nov 2024 | 23:59:11

Keyence EX-V Series Manual do Utilizador Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Keyence EX-V Series