Keyence EX-V Series Manual do Utilizador descarregar pdf (Página 74)

Chapter 4 Use of Data Processing Functions

4.4 Details of Thickness/gap Mode

This section describes function codes "A" to "d" specified with the key for the

thickness/gap mode.

4.4.1 No. of averaging measurements/Digital filter [A]

Sets the number of averaging measurements or the digital filter function.

➮

Refer to page 47 for details.

4.4.2 Measurement type [b]

The following three types of measurement are available:

Select or set the measurement type in the following procedure:

Reference: The thickness/gap mode is adjusted to increase measured values

when the distance between the sensor head and a target decreases. If you want to

decrease measured values when the measuring distance decreases, set function

"d" to "d-0", normal display.

Setting function "b"

1. Press the key for at least 2 seconds.

The sensor enters the common function selection mode.

2. Press the

key to make function "b" flash.

noitcnuF

.oN

epyttnemerusaeMnoitpircseD

ecnerefeR

egap

0-b

suounitnoC

tnemerusaemehtstuptuo/syalpsiD

.ylsuounitnoctluser

1-b

tnettimretnI

deificepsataeulavehtserusaeM

.tnatsni

76,66

2-b

egarevA

ehtfoegarevaehtsetaluclaC

deificepsagnirudseulavderusaem

.)doirepgnilpmas(doirep

86,76

The measured value increases.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 119 120

Lao 20 Nov 2024 | 23:59:11

Keyence EX-V Series Manual do Utilizador Página 74