Keyence FS-N10 Series Manual do Utilizador descarregar pdf (Página 17)

2-1 Installing Sensor Amplifiers

Installation and Connection

2-3

- Digital Fiber Sensor FS-N10 Series User's Manual -

• Contact your nearest KEYENCE office when connecting a unit

other than the N-bus (KEYENCE’s wire-saving system) compatible

sensor amplifier, including FS-N10 Series, or the NU Series com-

munication module.

• Turn the power off before connecting multiple expansion units.

• Do not touch the expansion connector with your bare hands.

• When using the FS-N10 Series as a main unit, use the products

within the expansion unit’s power voltage range if the power volt-

age range of the expansion unit is narrower than the FS-N10

Series.

Remove the protection covers from the main unit

and expansion unit(s).

Mount the main unit and expansion unit(s) on the

DIN rail.

Slide the main unit and expansion unit(s)

together. Engage the 2 claws of the expansion unit

with the recesses on the main unit side until you

hear/ feel a click.

Attach the separately sold end units (OP-26751: a

set of 2 units) to the DIN rail in the same manner

as step (2) (Tightening torque: 0.6N•m or less).

Secure the amplifiers between the end units.

Tighten the screws at the top (2 screws × 2 units)

with a Phillips screwdriver to fix the end units.

Point

Main unit Expansion unit

(3)

(2)

(1)

End unit

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 115 116

Sem comentários

Keyence FS-N10 Series Manual do Utilizador Página 17