Keyence FS-N10 Series Manual do Utilizador descarregar pdf (Página 36)

3-3 Adjusting Sensitivity

Basic Operation

3-14

- Digital Fiber Sensor FS-N10 Series User's Manual -

This method is used when you want to position a workpiece.

Press the [SET] button

once when no workpiece

is present.

Position a workpiece such

that its edge aligns with

the center of the project-

ing beam. Then, press

and hold the [SET] button

for 3 seconds or more.

Release the button when

"SEt" flashes.

Press the button to

adjust the setting value.

When performing two-point calibration on channel 2 of the 2-output type,

set the channel switch to " ".

Positioning Calibration

Workpiece

Reference

Setting

value

Time

Received

ht intensity

Calibration is complete after the setting value flashes momentarily, and then

stops (lights up).

The setting value is determined as the value of light intensity received when

the workpiece comes into position.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 115 116

Sem comentários

Keyence FS-N10 Series Manual do Utilizador Página 36