Keyence DL-RB1A Manual do Utilizador descarregar pdf (Página 15)

2-1 Connecting the Unit to Sensor Amplifiers

Mounting and Connecting the DL-RB1A

 Connecting the DL-RB1A to DIN rail mounted sensor amplifiers

1 Remove the expansion protective cover from the sensor amplifier that is to be connected to the

DL-RB1A.

2 Mount the DL-RB1A on a DIN rail and connect it to the sensor amplifier.

Make sure there is no space between the DL-RB1A and the sensor amplifier.

3 Mount the end units (OP-26751, two units included) on either side of the sensor amplifier and

DL-RB1A unit and tighten the two screws on the top of each end unit.

(You can mount the end units in the same way you mount DL-RB1A.)

Sensor amplifier

Expansion protective cover

Sensor amplifier

DL-RB1A

Connector

Caution

Check that the sensor amplifier connector

(for DIN rail mounting) located on the side of

DL-RB1A is not installed at an angle as

shown in the illustration to the right.

Connecting the unit with its connector

installed crooked to a sensor amplifier may

damage the unit.

Sensor amplifier connector

DL-RB1A

Caution

Make sure to firmly insert DL-RB1A all the way into the sensor amplifier.

Turning the power on when the unit is not inserted straight or firmly

connected could damage the unit.

End unit

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Sem comentários

Keyence DL-RB1A Manual do Utilizador Página 15