Keyence DL-RB1A Manual do Utilizador descarregar pdf (Página 9)

1-1 Before Using the Unit

Introduction

(1) Advanced setting switches

You can use different ON/OFF combinations to configure the output settings.

• Make sure you cycle the power to the unit after modifying

the settings. The modifications are not applied to the unit

until it is powered down and power has been reapplied.

• Place the switch protection sticker supplied with the unit

over the switches after you modify the settings.

Switch No. Setting item Combination

1Output logic

Setting enabled only for BCD output (Pin Nos. 6 to 29) and

BCD polarity code output (Pin No. 30).

* Factory default positions are shown.

Negative logic: The bit for each BCD output will be 1 when the

BCD output (Pin Nos. 6 to 30) is on.

Positive logic: The bit for each BCD output will be 1 when the

BCD output (Pin Nos. 6 to 30) is off.

BCD data

output method

Set the method for handling all outputs except for the alarm

output (Pin Nos. 6 to 31).

* Factory default positions are shown.

Do not use combinations other than those shown above for

switch numbers 2 and 3.

BCD output update

cycle time in the

TIMER mode

* Factory default positions are shown.

Negative logic*

Positive logic

OUT mode* OR mode TIMER mode

Note

ON ONON

45 6

ON ONON

45 6 45 6 45 6

45 6 45 6 45 6 45 6

1ms

2ms 4ms 8ms

16ms 32ms 64ms 128ms

Note

Switch protection sticker

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comentários a estes Manuais

Sem comentários

Keyence DL-RB1A Manual do Utilizador Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Keyence DL-RB1A